iButton

By | 15/04/2012

I followed Suvi’s instructions on how to get iButton working on the UNO.

The iButton had two wires, a white and a brown one. I connected the iButton on the breadboard. I connected the white wire to slot 7 on the UNO and to the 5v through a resistor. I connected the brown wire to ground.

After the wires were in place I went to http://arduino.cc/playground/Learning/OneWire to get the library as Suvi had instructed. Once the OneWire is extracted copy it to the folder arduino-1.0libraries

Suvi’s code. There is also a video of the iButton in action.

Leave a Reply

Your email address will not be published. Required fields are marked *